管道和电缆定位仪715
添加时间：2010-10-15 编辑：X061 阅读：次
- 产品名称：管道和电缆定位仪715
- 产品定货号：MS-00184-00
|
|
全固态。 继电器或接触没有穿。
紧凑，坚固，轻便。
温度稳定
证明了数千名用户现场条件下的坚固。
信号的频率和速率可变灭弧调整最佳信号。
接收器具有高灵敏度的四阶段放大器。
源运行在12伏直流电源。可以采用外部汽车电池。
可充电可凝胶电池。
接收器和发射器互锁，以防止对存储转为单位。
灭弧室是信号的频率和速率可变，使操作者调整最佳信号。
三个输出阻抗范围为级放大器。
维修有限公司改变或充电电池。
|
Model 715 by Nilsson Electrical Laboratory Inc. is an all solid state, conductive-type pipe and cable locator.
It is great for solving cathodic protection problems as well as determining exact location and depth of pipes and cables.
A signal is applied to pipe or cable and can be accurately followed over long distances.
The transmitter tone is designed with variable frequency and interrupter rate, and can be adjusted for distinctive signal under any conditions.
It has three output impedance taps for efficient matching to all soil conditions.
The Transmitter and Receiver are interlocked, preventing storage with batteries turned on.
Power can be provided by a 12 Volt lantern battery or by a external 12 Volt source.
A battery warning light indicates when the battery needs to be replaced.
Model 715 can also be powered by an external rechargeable 12 Volt Battery, Nilsson Model 110 (described below).
The transmitter and receiver assembly are housed in a rugged, lightweight, weatherproof aluminum case measuring 7" x 7" x 11". This case provide ample storage room for accessories. Approximate weight is 9 lbs.
泰亚赛福 —— 世界领先的检测仪器集成供应商 
您当前的位置：
加入对比
