DI-12-4产量扭力测试仪

DI-12-4 Yield Torque Tester

 

DI-12 motorized torque tester is designed to find the actual yield tightening torque value for specific thread joints which consist of a variety of thread types, multi-layered material, hole sizes, etc.

The yield value is the point at which the torque angle is no longer linear. Once the yield tightening torque value is found, one can easily determine the proper tightening torque value.

DI-12 also captures the difficult-to-detect first peak dip in actual tightening torque of small screws. DI-12 provides a steady slow speed to capture the very small first peak dip and stops automatically to avoid over tightening.

Torque data can be continuously output via RS-232 enabling you to display a torque profile showing, peak down, yield, and destructive strength torque using data acquisition software. 

Model

Range

DI-12-SL4

0.30 – 35.00 lbf-in

DI-12-SL4oz

3.0 – 560.0 ozf-in

DI-12-SL4kg

0.30 – 40.00 kgf-cm

DI-12-SL4cN

3.0 – 400.0 N-cm

DI-12-SL4N

0.030 – 4.000 N-m

 

 

Auccracy

±1% F.S., 1LSD 

Display

4 digit LCD Display 

Operation

Both CW and CCW motorized rotation 

Measurement Modes

P-P: Displays PEAK Torque value that will not change until a higher value is measured.
T-R: Displays TRANSIENT torque values.
RG: Determines peak down and yield torque (CW only)
If a peak down torque value is detected, the green indicator will light, and tester rotation will stop automatically. 

Test Start Value

Start of RG Mode can be set in 0.001 N-m increments. 

RS-232 Output

Continuous (9600 baud) output in PP and RG measuring modes. 

Auto-power-off

After 5 minutes of non-use. 

Drive

1/4" Hex