Model TX-KXP-DModel TX-KXP-D有毒气体检测器

Toxic and Corrosive gas monitor with intrinsically safe transmitter

NEMA 4X IP65 water resistant enclosure

No flame arrestors required. Prevents any loss of absorbing mineral acid gases

Plug-in renewable electrochemical sensor

Non-intrusive One-man remote calibration

Back lit digital gas concentration display

 toxic and corrosive gas detector is designed specifically for hazardous areas. The monitoring system is useful for leak detection of toxic, corrosive and mineral acid gases in chemical plants, refineries and other locations where explosive or flammable gases may be present.

Available with digital display, here are some of the other advantages of the PureAire’s  provides protection from corrosive and mineral acid ages in areas where flammable gases may also be present, through the use of an intrinsically safe barrier.

The  monitoring system can be calibrated without opening the enclosure, therefore, eliminating the need for a hot permit.

PureAire cells are designed to operate even in 100% RH conditions, such as condensing vent streams. As a result, there’s no need for expensive extractive sampling systems.

PureAire’s sensor cells are not affected by rapid changes in temperature or humidity, and offer interference free monitoring outdoor on fence lines.

Themonitoring system can be remote up to one mile from centralized control systems.

For installation versatility, the 4-20mA signal interfaces with any independent alarm, control or surveillance system, as well as PureAire’s dedicated controller.

PureAire renewable sensor cells are easily recharged with electrolyte, right in the field, at approximately 1/4 the cost of disposable sensor cell type systems. Recharge costs typically run about $35.00 per sensor, every 6 months.