AMCORR EZ Wrap is a versatile and economical sealing product with excellent sealing properties for a wide range of applications such as leakage prevention or environmental encapsulation. It works as a corrosion barrier, vapor barrier, water stop or encapsulation agent. It has immediate adhesion to any dry surface such as steel, PE, PP, epoxy, polyurethane, PVC, etc. without roughening. It is strengthened by a fiber mesh that is imbedded in the middle of the material

AMCORR EZ Wrap allows economical and rapid installation in almost any situation above or below grade, including concrete structures, sewer lines and steel pipelines. Dispensed on a roll with 70 mil (1.8 mm) thickness, it is easy and safe to apply. No primers or solvents are involved, no heating is required, and there is no hardening time. A white polyester non-woven fiber top layer allows immediate painting or coating after installation. The material is storage stable (dry/cool) with an unlimited shelf life. It remains flexible even after decades.

Amcorr EZ Wrap (patent pending) is engineered for use in many water leak applications, offering long-term performance in commercial, residential, telecommunications, utilities, transportation, electrical, water, wastewater, agricultural, and industrial as well as others. Primary applications are sealing around rooftop vents, pipes, metal roof seams, flashings, residential and commercial roofing, EPM roofing, and cable entries, holes and voids, cracks, storage tanks, industrial pools, swimming pools, manholes, basements, floors, cable joints and repairs, and etc. It is also used in conjunction with other Amcorr Products such as Amcorr EZ Paste. It is a long-term solution for:

Prefab joints

Gravity fed pipes

Encapsulation of asbestos pipe, lead base paints, etc.

Manhole and I&I applications

Roof seal for penetrations, seams, cracks, transition

Pipe Crossings

Tank Chime

Seam sealant for exterior sheathing, insulation, sheet metal

Physical Properties

Amcorr EZ Wrap is a mastic-like material designed with synthetic properties that will adhere to almost any surface without a primer. It comes in rolls and is designed to be used as a permanent solution for water leaks.
 

Easy to apply Long term protection Non toxic Weather/salt resistant Works from -22°F to 158°F Patented technology Cold applied Environmental friendly No primers

UV resistant Weather resistant Molds and forms easily Solving difficult problems Compatible with dry coatings Tested according to latest specifications ISO9001 Made in the USA Dispensed in 70 mil rolls

 

Color	Gray
Paintability	Polyester back can be painted
Odor	None
Density	1.4
Perm Ratomg	< 0.0001 perms
Water Intake	< 0.0008 lbs/oz
Resistivity	1012 ohm-cm
Viscosity	Viscous elastic solid (putty like)
pH	Neutral
Shelf Life	Unlimited
Max Operating Temperature	158°F
Min Operating Temperature	45°F
Water Intake	0%
Adheres to Wet Surface	No
Min Temperature (no cracks)	-22°F
Application	Above and below grade
Safety	No unusual hazards are known or expected. Observe normal safety procedures during installation. See MSDS.

EZ Wrap application to a pipe surface

Application to a concrete surface

Clean the application surface with a dry cloth. Remove as much loose material as you can.

Peel off the clear release liner from the roll of EZ Wrap and align the EZ Wrap with the applicaiton surface.

Use a Steel Seam Roller to press the EZ Wrap to the surface.

In cold weather, preheat the surface using a hot air blower or a hot air gun, or preheat the rolls in a heated cabin or car.

Within half an hour to an hour of application, peel EZ Wrap away from the side to see if full adhesion has occurred. If not, press down with a seam roller and/or heat the area with a hot air blower or heat gun.