首页 > 工程物探测绘 >  阴极防护/腐蚀控制 > 腐蚀控制产品 > 特种防腐涂料 > Tapecoat 20煤焦油热应用防腐涂层
Tapecoat 20煤焦油热应用防腐涂层
Tapecoat 20煤焦油热应用防腐涂层
订货号: MM-80619-00
产地: 美国
品牌:
开发编号: N
市场价:
*此产品根据配置不同价格不同
*此价格为参考价格,具体价格以订单合同为准
    我在现场:
    产品视频:
  • 产品描述
  • 技术参数
  • 技术文档
  • 相关产品
  • 明细价格
  • 购买流程
产品描述:

Composition
Tapecoat 20 consists of a specially formulated pliable coal tar coating completely saturated into and bonded to both sides of a high tensile strength fabric. In addition, it has a polyester film adhering to the coating which facilitates unwinding of the roll and acts as an outer wrap, providing additional mechanical strength against backfill and soil stress.
Technical Data
Softening point
-170°F ± 5°F (-77°C ± 3°C)
Penetration
0.3 to 0.8 mm at 77°F (25°C)
Thickness
58 ±2 mils (1.47 ± 0.05 mm)
ASTM G-8 C.D.
250 oz / inch width (2.79 kg/cm width)
Elongation
Passes
Oil & hydrocarbon resistance
Excellent
Specs & standards
Meets Federal Spec HHT 30a and AWWA Standard C203
Compatibility
Coal tar, asphalt, polyethylene, polypropylene, FBE and other factory coatings
Tests
ASTM E28, ASTM D5, ASTM G8, ASTM G20
Application
Equipment: A torch with wide mouth burner is recommended.
Surface Preparation: Surface must be clean and dry. Wire brush to remove any loose rust and scale, dust or dirt. Oil, grease and all other residue are to be removed from pipe surface. Use torch to warm the surface and remove moisture prior to priming.
Primer Application: TC Omniprime is the compatible primer for use with Tapecoat 20. Apply primer to the prepared surface by brush or roller at the rate of approximately 300 square feet per gallon. TC Omniprime should be applied 4" beyond the area to be wrapped with tape. Let primer dry before applying Tapecoat 20. TC Omniprime can also be used on stainless steel.
Tape Application: There are two recommended methods for applying Tapecoat 20 to a properly prepared and primed surface.
Spiral Wrap: Flash flame of torch onto the side of the coating without the polyester film (outside of roll) until a smooth and glossy finish is obtained. Apply properly heated coating with tension to the surface of the pipe. Alternately heat and spiral wrap in a single thickness with a continuous 1/4" to 1" overlap of tape.
Cigarette Wrap: Precut strips of Tapecoat 20 to a length equal to the circumference of the pipe plus a minimum of 3" for overlap. Follow general tape application instructions described above.
  
 


您最近浏览的商品

美国泰亚赛褔