Features of the Model V6-CF Controller

Firing Methods and Features which make firing easier:

CONE FIRE METHOD - use when firing to a specific cone number using one of four speeds, "Slow Bisque", "Fast Bisque", "Slow Glaze", or "Fast Glaze".

VARY-FIRE PROGRAMMER - Program up to 6 separate firing profiles for repeated use. Each profile may have up to 8 segments with separate heating or cooling rates, temperature set-points, and hold times. Use RECALL PROGRAM button to recall any firing program with one button ease.

DELAY START - Delay the start of your firing up to 99 hours and 99 minutes.

PREHEAT - Used with CONE FIRE method to hold a temperature of 200 癋 for a specified time prior to starting the firing. This can be used for drying ware.

ALARM - User set audible temperature alarm.

Advanced features:

CONE OFFSET - Used to raise or lower the final temperature of any cone to fine tune the controller to your kiln.

SKIP STEP -Skip from the present segment to the next ramp.

ERROR CODES - Error codes may be turned on so the kiln will automatically shut down if there is an error. They may be turned off for special firing profiles.

16 SEGMENT PROGRAMS - User programs 5 and 6 can be combined for a 16 segment program.

Messages and information:

REVIEW PROGRAM - Review your firing profile any time before or during the firing.

VIEW SEGMENT - View the current segment or skip to the next segment.

CONE TABLE - Easily look up temperature and cone number equivalents.

 

V6-CF Controller Specifications

THERMOCOUPLE INPUT	Available for K, S, or R
ACCURACY	+/- 10 °F
COLD JUNCTION COMPENSATION	ELECTRONIC
POWER INPUT	24V CENTER-TAP TRANSFORMER
OUTPUTS 1 & 3	150mA at 12V; one 12V relay with 80 Ohm coil per output
OUTPUTS 2 & 4	600mA at 12V ; four 12 V relays with 80 Ohm coil
OPERATING TEMPERATURE RANGE	0 TO 125 °F or 0 to 52 °C