DI-1M Digital Torque Tester for Air Tools & Impact Wrenches

DI-1M torque testers are perfectly suited for on-the-spot calibration of impact drivers and air tools, but will calibrate any type of power driver. These fast response units give a digital readout of peak value in either clockwise or counterclockwise direction and also indicate the number of blows for a selected time period from 0.1 to 9.9 seconds. These instruments have an accuracy of ±0.5%, ±1 LSD and lbf-in/lbf-ft, kgf-cm/kgf-m, or N-cm/N-m units are selectable. RS-232 output, auto zero reset, auto shutoff and low battery indicator complete the set of features. It is powered by an internal NiCad battery or the included AC adapter.

Peak, Real Time and Peak Down modes are selectable.
Peak mode captures the peak torque achieved during a test. PEAK reading will not change until a higher value is measured.
Real Time mode displays the real time transient torque value.
Peak down captures the critical first peak value and will not change even if a higher value is subsequently measured.

The DI-1M also provides peak data for SPC (statistical process control) via the RS232 port. Click on the link below for torque tester data acquisition software.

The DI-1M is supplied with the remote sensor, display unit, cable and AC adapter/charger.

Calibrate your own air tools and impact wrenches and save down time.

L-bracket sold separately. 

Model

Capacity

Drive Size

DI-1M-50

3.0 - 440.0 lb-in
3.0 - 500.0 kg-cm
30 - 5000 N-cm

3/8" Sq. Dr.

DI-1M-200A

30 - 1800 lb-in
30 - 2000 kg-cm
3.0 - 200.0 N-m

1/2" Sq. Dr.

DI-1M-200

3.0 - 145.0 lb-ft
0.30 - 20.00 kg-m
3.0 - 200.0 N-m

1/2" Sq. Dr.

DI-1M-500

3.0 - 362.0 lb-ft
0.30 - 50.00 kg-m
3.0 - 500.0 N-m

3/4" Sq. Dr.

 

 

 

The readings displayed may vary from the actual torque that a tool applies to a thread joint, because testers cannot always duplicate actual joint characteristics. Verify the torque output of the tool being used on the actual assembly, when critical assemblies are involved.