SDT Multi-Transmitter - Single Power

 

SDT manufactures two Ultrasonic Transmitters for verifying tightness integrity (wind noise, water leaks, weather tightness etc? of any volume; The SDT 200mW and the SDT 8 Multi Transmitter. The SDT 8 Multi Transmitter (pictured left) is for use in large volumes such as cargo ships, submarines and other navy vessels with watertight doors, buses, trains, airplanes, passenger vehicles etc

 

Ultrasonic transmitters generate dual high frequency signals. These signals are small and therefore able to pass through very small leaks. When the transmitter is placed inside a volume (cargo hold for instance) the entire volume is flooded with dual ultrasonic waves. Use an SDT ultrasonic detector outside the volume to find and pinpoint the exact point of leakage.

 

 

SDT Ultrasonic Testing is Type Approved worldwide by major shipping classification societies such as ABS American Bureau of Shipping, Lloyds Register, and DNV. P&I Clubs around the world recognize SDT ultrasonic hatch cover inspection as a major contributor to the reduction of insurance claims from water damaged cargo. Use the SDT 08 Multi Transmitter with the SDT Sherlog Detector for Type Approved inspection and data collection of hatch cover weather tightness.

 

Testing Automobiles on the Assembly Line:

SDT Ultrasonic is widely used by major manufacturers such as Ford, Daimler Chrysler, Toyota, Mitsubishi, Hyundai, General Motors, Bombardier, and others. The elimination of water shower booths on assembly lines is the primary motivation for integrating ultrasonic tightness testing into the quality control applications for wind noise and water leaks. The principles are the same for automobiles and hatch covers.

The SDT 8 transmitter is equipped with a lead-acid battery and weighs approximately 2 lbs. The equipment can be used in temperatures ranging from 5to +50.

 

1. The ultrasonic sensors

Eight sensors are laid out in the equipment such that they transmit in the volume of a hemisphere.Each ultrasonic sensor is frequency and power stabilised. The transmission frequency is 39.2 and 39.6 kHz (bi-sonic mode) at a power of 125 mW.

2. Indicator

A red indicator integrated in the ON - OFF switch shows whether the equipment is switched on and the charge level of the battery according to the following code:

Indicator Equipment On - Equipment switched on. - Battery charge correct.

Flashing - Equipment switched on. - Battery charge incorrect.

The speed of the flashing increases as the charge decreases.

Off - Equipment switched off or - With switch in on position indicates an insufficient charge.

3. The ON-OFF Switch

Located at the base, this switch enables the equipment to be switched on (ON position) or off (OFF position).

4. The Charge Plug

Marked LOAD (charged), it enables the internal lead battery to be recharged without taking the equipment apart. Overcharging is not possible if the charger delivered with the equipment is used.

5. The Battery

Lead-acid type and sealed, the battery is accessible after the lower protection lid has been removed. The rated voltage is 12V and its capacity is 1.2 Ah at 20 C; the autonomy is 2.5 hours for a 6 hour charge.

 

Transmission Characteristics:

Function: Ultrasonic Transmitter

Frequencies: Stabilized at 39.2 and 39.6 kHz (bi-sonic mode)

Number of transducers: 8

Transmission power: Stabilized at 8 x 125 mW

Dispersion: 8 x 60?/DIV>

Supply Voltage/capacity: 12V DC/1,2 Ah

Battery: Gelled lead-acid rechargeable

Recharge: By means of an external charger and integrated connector (without removing the battery) or by using a charge adapter (removing the battery).

Autonomy: 2.5 hours at 20

Charging time: 6 hours

Safety: Chemical control fuse with automatic reset.

On/Off switch:

Command: By ON/OFF switch

Visual indication: ON/OFF/battery charge control indicator. Flashes when undercharged.

 

Temperature range: -4癋 to 122癋 (-20?C to +50?C)

Hygrometry range: 0 to 95 % RH non condensing

Dimensions: Length: 6.3?x Width: 3.9?x Height: 3.75/DIV>

Weight: 3.3 lbs

Order Number FS8US or FS8MSUS contains:

FUSUIT8 Plastic case (blue) SDT8 + foam

FU8S or FU8MS SDT 8 Standard or Multi Setting with battery and user manual

FUPS8US/EU/AS Battery charger for SDT 8 (US=110VAC, EU=240VAC Europe, AS=240VAC Asiatic)

FUBATAD8 Battery charger adapter SDT 8

FUBAT8 Battery pack SDT 8

FUHOLSLEATH8S Leather case for SDT 8 with shoulder trap

FUTOSCRDRIV Screw driver for battery cover