GD10P二氧化碳红外气体检测仪

添加时间：2010-2-9 编辑：C055 阅读：次

加入购物车

加入对比

产品名称：GD10P二氧化碳红外气体检测仪
产品定货号：MR-06521-00

产地：其它
推荐：

This ultimate Infra-Red point detector with filter wavelenghts for CO2 detection. GD10P may be stand-alone duct mounted, or used in sampling systems.

Features

Life-time stability

The SimSource infrared light source is a solid-state component with a stable output and 60years of expected lifteime. This, together with the Simrad Optronics IR-path design gives you a detector with unparallelled stability.

No false alarms

Unlike most gas detectors in use today, the GD10P will give an error signal and not cause gas alarms in case of detector failure.

No poisioning or saturation

Immune to silicon vapours, H2S and other widely used agents.

High gas concentrations will not saturate the detector.

Can be used to detect gases where oxygen is not present, e.g. in sub-sea production units

Low maintenance costs

GD10P requires no regular field maintenance, apart from cleaning the optics. It has a fixed factory calibration, and is not recalibrated during its lifetime.

SAFE

Application

Chemical industry

Underground facilities

Tunnels

Specification
General
Detection method	IR-absorption, dual wavelength, dual path
IR-Source	Solid state IR source, 50Hz flash
Gases detected	CO2
Self-test	Continuous
Calibration	Factory set, no field recalibration
Performance
Lifetime stability	±5% of full scale (FS) reading
Accuracy	±3% FS between 0-50 % reading
	±5% FS between 50-80 % reading
Response time	T20 = 1 sec.
	T50 = 2.5 sec.
	T90 = 6 sec.
Start-up time	Less than 60 sec.
Output signal
Standard	Current source 4 – 20 mA, max. load impedance 500
Option	Current sink 4 – 20 mA
Option	HART®
Electrical
Power supply	24 V DC, range18-32 V DC
Power consumption	Approx. 3.5 W
Connection	3 wires (0.5mm2 - 1.5mm2)
Cable entry	M20 EExe cable gland
Temperature range
Storage	-40°C to + 70°C
Operating	-20°C to + 45°C
Humidity (operation)	100% RH
Explosion proof housing
Main compartment	EExd IIC T6
Terminal comp.	EExe
Protection category	IP66/IP67 DIN 40050
Housing material	Stainless steel SIS2343 (ASTM 316)
Approvals
ATEX	Directive 94/9/EC, EMC directive 89/336/EEC Article 4
SAA (Simtars)	AS 2380.1 / 2380.2 / 2380.6
ABS	# 04-LD444057-PDA
SIL	Qualified for SIL2 systems
Versions
Standard ranges	10000ppm (1%), 3%, 5% 10% and 100%

产品名称	产品简介	产品编号
GD10P二氧化碳红外气体检测仪	This ultimate Infra-Red point detector with filter wavelenghts for CO2 detection. GD10P may be stand-alone duct mounted, or used in sampling systems.	MR-06521-00