示波器

产品导航

您当前的位置：电工仪表 >> 示波器 >> 模拟示波器 >> OS-3060D模拟示波器

OS-3060D模拟示波器

添加时间：2009-12-9 编辑：读取中…… 阅读：次

加入购物车

加入对比

产品名称：OS-3060D模拟示波器
产品定货号：ME-01795-00

产地：韩国
推荐：

OS-3060D模拟示波器

特性介绍

数字和模拟示波器组合的性能
2通道同步取样的速率最大为20MS/s
信号重复等效值60MHz
每个通道存储量达2K字节
实时切换和存储模式
双存储记忆体模式
机板预先触发，使得波形线性比例观察点生效
卷模态提供连续观察慢性波形
平均功能提供总和平均达到256倍
线性和正弦窜改功能最适合正弦或脉膊曲线信号
放大功能可详细观察波型
读数功能可将所测量的电压时间频率显示在屏幕上
用HP-GL指令和RS232界面卡现存可直接拷贝现存屏幕显示

规格

OS-3020D

OS-3040D

OS-3060D

CRT阴极管

配置和有效视频

6 inch rectangular screen with internal graticule: 8x10DIV (1div=1cm), marking for measurement of rise time. 2mm subdivisions along the central axis.

加速电势

+1.9kV approx

+11.5kV approx

荧光器

P31 (Standard)

聚焦

Possible (with auto - focus correction circuit)

旋转线迹

provided

比例照明

Variable

亮度控制

provided

高强度Z轴输入

输入信号

Positive going signal decreases intensity + 5Vp-p or more signal cases noticeable modulation at normal intensity settings

频宽

DC to 2MHz (-3dB)

触发耦合

输入阻抗

20kOhm - 30kOhm typical

最大输入电压

30V (DC + peak AC)

垂直偏转

频宽

(DC Coupled)
DC to 20MHz normal
DC to 7MHz magnified

DC to 40MHz normal
DC to 7MHz magnified

DC to 60MHz normal
DC to 10MHz magnified

模式

CH1,CH2,DUAL,ADD (CHOP: Time/div switch -0.2s to 5ms, ALT: time/div. switch -2ms to 0.2us)

CH1,CH2,DUAL,ADD (CHOP: Time/div switch -0.2s to 5ms, ALT: time/div. switch 2ms to 0.1us)

偏转系数

5mV/div to 5V/div in 10 calibrated steps of a 1-2-5 sequence.
Continuously variable between steps at least 1:2:5
(x5 MAG : 1mV/div to 1V/div 10 calibrated steps)

准确度

Normal: +/-3%, magnified: +/-5%

输入阻抗

Approx, 1Mohm in parelle1 with 25pF+/-3pF

最大输入电压

Direct 250V (DC + AC Peak) (with probe: refer to probe specification)

输入耦合

DC- GND - AC

延升时间

17.5ns or less (50ns or less: x5)

8.8ns or less (50ns or less: x5)

5.8ns or less (35ns or less: x5)

通道1 输出

20mV/div into 50ohm : DC to 10MHz (-3dB)

极性逆向

CH2 only

信号延时

Delay cable supplied for OS-3040D / OS-3060D

水平偏转

显示方式

A, A int B, B, TRIGD, X-Y

A 时基

0.2us/div to 0.2s/div in 19 calibrated steps 1-2-5 sequence, uncalibrated continuous control between steps at least 1:2:5

0.1us/div to 0.2s/div in 20 calibrated steps 1-2-5 sequence, uncalibrated continuous control between steps at least 1:2:5

锁定时间

Variable with the holdoff control

B 时基

0.2us/div to 20us/div in 7 calibrated steps 1-2-5 sequence

0.1us/div to 0.2us/div in 20 calibrated steps 1-2-5 sequence

延时扫描

1 div or less to 10 div or more

延迟抖动

better than 1:20000

扫描放大

10 times (maximum sweep rate : 20ns/div) Note: 50ns/div, 20ns/div of A TIME BASE are uncalibrated

10 times (maximum sweep rate : 10ns/div)

准确度

+/-3%, additional error for magnifier +/-2%

触发系统

触发模式

AUTO, NORM, TV-V, TV-H

触发源

CH1,CH2,LINE,EXT

耦合

倾斜率

+ OR -

TV-V, TV-H

At least div or 1.0Vp-p Composite Sync.

外部触发输入阻抗

1Mohm

最大输入电压

250V (DC + Peak AC)

灵敏度和频率/自动和标准

	20Hz-2MHz	2MHz-20MHz
INT	0.5div	1.5div
EXT	0.2Vp-p	0.8Vp-p

	20Hz-2MHz	2MHz-20MHz
INT	0.5div	1.5div
EXT	0.2Vp-p	0.8Vp-p

	20Hz-2MHz	2MHz-20MHz
INT	0.5div	1.5div
EXT	0.15Vp-p	0.3Vp-p

X-Y轴操作

X 轴

(Same CH1 except for the following) Deflection factor; same as that of CH1/Accuracy : +/-5%/Frequency response: DC to 500kHz (-3dB)

Y 轴

Same as CH2

X-Y 轴相位相差

3º or less (at DC to 50MHz)

直读功能

游标读数功能

Voltage reference △V: △-REF, Frequency reference 1/△T: △-REF

面板设置显示

Verical axis CH1,CH2: V/div, UNCAL,MAG (converted value)
Note: displayed when the vertical mode is CH1,CH2,DUAL,ADD not displayed when the B node
Horizontal axis: S/DIV,UNCAL,MAG (converted value)

Effective Cursor Range from Center Graticule

Vertical: within +/-3div, Horizontal: within +/-4div

解析度

1/25 div

数字储存功能

显示记忆体和储存记忆体

1000 Words/CH,1000 Words/CH x 2

Acquisition Memory

5us/div-20s/div: 2000 words/CH
0.2/div-20us/div: 1000 words/CH

5us/div-20s/div: 2000 words/CH
0.1/div-2us/div: 1000 words/CH

垂直解析度

25 point/div

水平解析度

100 point/div

最大取样速率

20MS/s

数字频宽/单状态效应

5MHz

Repetitive Event

20MHz

40MHz

60MHz

Data Acquisition Method

NORM mode: storage the data each time trigger
AVG mode: averaging from 4 to 256 times
ROLL mode: data is continuously stored on the CRT
HOLD mode: data is held for the NORM, AVG.ROLL
SINGLE: wave form is held after stored
AMAG mode: simultaneously displaying the original waveform and its nagnified waveform
G-NG mode: judgement and comparing of acquisition signal

储存数据

Up to two storage data can be saved.
Saved data can be recalled to the display whenever required.

Pre 触发

Variable (0.04 div step)

Plotter

Plotter output of the CRT displayed information to an HP-GL.
Plotter via the RS-232C interface

数据输出

RS-232C

Magnified Display

X 10 by Time/div switch or MAG switch

X-Y 轴操作

Single trace X-Y X axis=CH1 * X axis=SA, Y axis=CH2 * Y axis=SB
Dual trace X-Y X axis=CH1 * Y axis=CH2
Sensitivity X axis:CH11 mV-5V/div +/-5% Y axis=CH2 1mV=5V/div+/-5%
Phase error 3° or less from DC-50kHz

Sweep Time

0.2us/div-20s/div rejpetitive signal: 0.2us/div-2us/div
roll mode: 0.5s/div-20s/div ALT: 0.2us/div-0.5ms/div
CHOP: 1ms/div-20s/div

0.1us/div-20s/div rejpetitive signal: 0.1us/div-2us/div
roll mode: 0.5s/div-20s/div ALT: 0.1us/div-0.5ms/div
CHOP: 1ms/div-20s/div

Readout Function

(Panel setting display)
V/div, uncal, MAG, S/DIV, uncal, MAG
X-Y, Trigger point ,number of averaging , roll mode, smoothing, interpolation method,
save memory information, probe setting (cursor readout)
Voltage differnce △V: △-Ref, Time difference △T: △-Ref,
frequency 1/△T: △-Ref, Pre-trigger TRG: △

校准器

Probe Adjustmetn

approx. 1kHz frequency, 0.5V(+/-3%) square wave duty ratio: 50%

电源供应

Voltage Range / Frequency

100,120,220,240, VAC +/-10%, 50/60Hz

功率

approx. 65W

物理参数

重量

approx. 8.5kg

体积

320)W)×140(H)×430(L)mm

环境参数

Temperature Range for Rated Operation

+10℃ to +35℃ (+50℉ to 95℉)

Max. Ambient Operating Temperature

0℃ to +40℃ (+32℉ to 104℉)

Max. Storage Temperature

-20℃ to +70℃ (-4℉ to 158℉)

Humidity Range for Rated Operation

45% to 85%RH

Max. Ambient Operating Humidity

35% to 85%RH

产品名称	产品简介	产品编号
OS-3060D模拟示波器	OS-3060D模拟示波器特性介绍数字和模拟示波器组合的性能 2通道同步取样的速率最大为20MS/s 信号重复等效值60MHz 每个通道存储量达2K字节实时切换和存储模式双存储记忆体模式	ME-01795-00