泰亚赛福 —— 工业设备集采平台
努力为您创造价值
智能 编号 品牌
 您当前的位置:首页 >> 品牌 >> MI >> 环氧树脂涂料
产品目录
品牌简介
推荐产品
热销产品

Tapecoat7030高温环氧树脂涂料

2010/11/10 10:41:50 阅读:568次

  • 产品系列名称:Tapecoat7030高温环氧树脂涂料
  • 产品定货号:MS-00423-00
  • 产地:美国
  • 品牌:MI
  • 推荐:
Description
Tapecoat TC 7030 High-Build, High-Temperature Epoxy is a one-coat, stand-alone protection that exceeds all performance criteria for prevention of corrosion of above and below ground metal surfaces. This tough coating can be used for any general application including high temperature pipelines with a maximum constant operating temperature of up to 250°F (121°C).
TC 7030 is an environment-friendly two-component, 100% solids material that provides up to 30 mils of high-build thickness for tough abrasion resistance-to-backfill and soil stress damage. This surface-tolerant epoxy provides exceptional corrosion prevention for reconditioning pipelines, protecting joints, patching pipeline coatings, and covering irregular fittings and metal surfaces.
Specifications
Color
Red. Additional colors available upon request.
Pot Life
15 to 20 min at 70°F (121°C) and 50% R.H.
Max Constant Operating Temp
250°F (121°C)
VOCs
Zero
Mixing Ratio
3.6:1 by volume
Labeling
No Red Label required
Application
Surface must be clean and dry. Commercial blast to SSPC-SP6. Remove oil and grease with suitable solvent. Salt and other contaminants may be removed by high pressure fresh water cleaning. Pour entire contents of Part B Curing Agent (small container) into Part A Resin (large container), and mix thoroughly for approximately 3 to 5 minutes. Do not alter the amounts of A and B in the mixture. Apply epoxy by brush, pad, roller or spray.
Primer should be dry to touch before applying Tapecoat hot applied tapes or sleeves. As a stand alone coating, TC 7030 Epoxy provides superior corrosion protection above and below ground.
Specially selected Tapecoat reinforcing scrim can be applied over wet epoxy. After scrim has been applied, apply a second coat of TC 7030 Epoxy.
Application Parameters
Environment, Use only when the surface to be coated is above 40°F (4°C) and the relative humidity (R.H.) is less than 90%.
Application temperature, 40°F-250°F (4°C-121°C). Surface temperature must be 5°F
(3°C) above the dew point to avoid condensation.
Cure time, 60 to 90 minutes at 70°-80°F (21°-27°C) and 50% R.H. Cure time can be accelerated by preheating the metal surface to 100°F-200°F (38°-93°C).
Recommended coverage, Single-coat, stand-alone coating: 30 mils (0.76mm) thickness, with a coverage of 53 sq. ft. per mixed gallon (1.23 m2/liter)
 
 

产品编号 产品名称 产品简介 产品价格
MS-00423-00 Tapecoat7030高温环氧树脂涂料 0¥

相关产品