泰亚赛福 —— 工业设备集采平台
努力为您创造价值
智能 编号 品牌
 您当前的位置:首页 >> 品牌 >> SEFRAM >> 信号发生器
产品目录
品牌简介

  Sefram为B+K Precision集团旗下品牌之一,公司设立于法国,创建于1947年,拥有60年的丰富经验与高度信誉。Sefram专致于记录仪及电视信号分析仪器的生产与研究,产品于欧美拥有极高的声誉,Sefram将以卓越的技术为您提供最精准的测量与分析。

>>品牌详情

推荐产品
热销产品

BK4013DDS信号发生器

2009/12/20 0:21:13 阅读:338次

  • 产品系列名称:BK4013DDS信号发生器
  • 产品定货号:ME-02779-00
  • 产地:法国
  • 品牌:SEFRAM
  • 推荐:
DDS function generator
Max frequency 12 MHz
Variable amplitude offset and symetry
Lin and log sweep
LCD display with backlight
Accurate, simple and easy to use
 
Specifications
Model 4013DDS
Waveforms
Sine, square and triangle waveforms
Operating Modes
Continuous
Output continuous at selected frequency.
Symmetry
Square symmetry is continuously adjustable from 15% to 85%.
Sweep
The output waveform can be linear or logarithmic internally swept, up or down, over the full unit range. The sweep start and stop frequencies can be independently adjusted and the sweep rate can be set from 100ms to 30s.
Frequency Characteristics
Range
0.1 Hz to 12 MHz for Sine and Square waveforms. To 1 MHz for Triangle waveforms.
Control
The frequency is selected with front panel up or down keys and modified with a rotary digital control.
Display
Up to 4 digits with large, bright LCD, ranging units (MHz, kHz, Hz and mHz) and decimal point. Waveform accuracy is 0.01% (100 ppm).
Output Characteristics
Amplitude Range
Up to 10 Vp-p into 50Ω (20 Vp-p into open circuit)
Amplitude Control
> 20 dB continuously variable.
Amplitude Attenuator
20 dB.
Amplitude Flatness
±1 dB to 12 MHz.
Offset Range
Variable up to ±10V (±5V into 50Ω). Absolute peak amplitude plus offset limited to ±10V (±5V into 50Ω).
Output Impedance
50Ω
Output Protection
The generator main output is non-destructively protected against short circuit to ground or to any voltage practically available in electronic laboratories.
Waveform Characteristics
Harmonic Distortion
< -55 dBc, 0 - 20 kHz (< 0.25%)
< -50 dBc, 20 kHz - 100 kHz
< -45 dBc, 100 kHz - 1 MHz
< -35 dBc, 1 MHz - 12 MHz
Spurious
< -55 dBc, 0 - 1 MHz
Triangle Linearity
> 99% to 100 kHz.
Square Transition Times
< 20 ns (10% to 90%) at full output amplitude terminated into 50Ω.
Inputs and Outputs
Sync Out
TTL level square wave at generator frequency, in phase with main output and 50Ω impedance. Can drive > 20 TTL loads.
General
Operating Temperature
0°C to +50°C
Power Requirements
100V - 240V, ±10%, 48 - 66 Hz single phase, < 25 VA.
Dimensions
8.4'' (213 mm) wide;
8.3'' (210 mm) deep;
3.5'' (88 mm) high, without bumpers.
Weight
Approx. 2 kg
Regulatory Standards
IEC 1010-1, Insulation category II, Pollution Degree 2.
EMC
EN50081-1 and EN50082-1.
CE Labeled

产品编号 产品名称 产品简介 产品价格
ME-02779-00 BK4013DDS信号发生器 DDS function generator Max frequency 12 MHz Variable amplitude offset and symetry Lin and log sweep LCD display with backlight Accurate, simple and easy to use 0¥

相关产品