2010/12/10 11:08:22 阅读:428次
Description
Denso Protal ARO is a VOC free, 100% solids liquid epoxy coating formulated to be applied over FBE as an abrasion resistant overlay (ARO) pipeline coating. It is a 3:1 ratio two-component coating compatible with most plural component spray units. This coating that can be spray or hand applied in the field or shop.
Uses
Denso Protal ARO is used to protect FBE mainline coatings and over Protal 7200 on girth welds during directional drilling, bores, river crossings and other rough terrain applications. Protal ARO can be used to provide additional protection to the coating on bends, fittings and fabrication when severe handling or rough terrain persist.
Features
Excellent gouge and abrasion resistance
Fast touch dry and set times
High temperature resistance (up to 150°F
High build (up to 60 mils in one coat)
Excellent adhesion to FBE and Protal 7200
Safe and environmentally friendly
Does not shield cathodic protection
Can be applied with brush, roller or spray
Not applied direct to steel
Application
By Hand:
Prepare FBE coating with a light sweep blast to remove gloss and roughen surface. After sweep blast wipe entire surface with MEK or approved solvent to remove all dust and other surface contamination. The equipment should be a plural component airless spray unit with a proportioning pump capable of a volume mixing of 3:1. Standard ancillary equipment should include minimum 10 gallon hoppers, static mixers, whip hose and spray gun. (Applicator should consult with Denso regarding recommended equipment). A wet on wet spray technique should be used to achieve the required film thickness. A wet film thickness gauge should be used to measure mil thickness. Spray:
Prepare FBE coating with a light sweep blast to remove gloss and roughen surface. After sweep blast wipe entire surface with MEK or approved solvent to remove all dust and other surface contamination. Add the hardener to base and mix until a constant color is achieved making sure all sides of container are scraped. Pour mixed material onto surface and apply to required mil thickness. A wet film thickness gauge shall be used to measure mil thickness. For complete application instructions, please refer to Protal ARO Hand or Spray Application Specifications. |
产品编号 | 产品名称 | 产品简介 | 产品价格 |
---|---|---|---|
MS-00556-00 | Protal ARO环氧涂料 | 0¥ |